Group 43 MID 130 Transmission Control Unit, Fault Codes MID 130 SID 231 SAE J1939 Data Link MID 130 SID 240 Program Memory Note: The boot program only sets this fault code during power-up. The boot program does not save any fault codes. MID 130 SID 250 SAE J1587 Data Link MID 130 SID 253 Calibration Memory EEPROM 53 Type of fault: FMI Description: Fault Condition: Possible Symptoms: Possible Cause: FMI 2 • Data erratic, intermittent, or incorrect • CAN 2 data link communication does not work • Yellow lamp is sent • Slow gear shifts • N/A Type of fault: FMI Description: Fault Condition: Possible Symptoms: Possible Cause:
FMI 2 • Data erratic, intermittent, or incorrect • Faulty data in program memory • Yellow lamp is sent • Cranking is inhibited • Engine cannot start • N/A Type of fault: FMI Description: Fault Condition: Possible Symptoms: Possible Cause: FMI 9 • Abnormal update rate • Signal from MID 128 PID 190, PID 85, PPID 212 is not received within 30s • Yellow lamp is sent • Slow gear shifts • Fault codes cannot be read • On-vehicle tests cannot be performed • N/A Type of fault: FMI Description: Fault Condition: Possible Symptoms: Possible Cause:
FMI 13 • Calibration value out of range • Flash checksum dataset error • Program code missing • Yellow lamp is sent • Cranking is inhibited • Engine cannot start • N/A