. OPERATION MACHINE OPERATIONS AND CONTROLS Warming-up Operation 1. Turn fuel control dial (1) to the center position between LOW IDLING and HIGH IDLING and run the engine at medium speed for about 5 minutes with no load. 2. Set safety lock lever (2) to the FREE position, and raise the bucket from the ground. (4) 3 - 77 NOTICE When the hydraulic oil is at a low temperature, d o not carry o ut operations or move the lever sudd enly. Always carry out the warming-up operatio n. This will help to extend t he machine life. p operation is completed.
Do not suddenly acc elerate the engine before th e warming-u p operatio n is Do not run the engin e at low idling or high idling continuous ly for more than 20 minutes. (Oil dow n) If it is necessary to run the engine at idling, apply a load from time to tim e or run the engin e at a mid-range speed. After starting the eng ine, do not immediately st art operatio perform the following operations and checks. 3. Operate bucket control lever (3) and ar m control lever slowly to move th of the stroke. e bucket cylinder and ar m cylinder t o the 4.
Operate the buck et for 30 seconds and the arm for 30 in turn fully for 5 NOTICE When the work equipm ent is retracted, take care th at it does no with the machine body