. OPERATION TRANSPORTATION LIFTING MACHINE WARNING 3 - 114 The operator carrying ou t the lifting operation using a cra ne must be a properl y qualified crane ope Never raise the machine Always make sure that th e wire rope is of ample strength for the weig ht of this Never lift the machine wit h the upper structure swung to th e side. Alwa ys set th e upper structure pa rallel to the undercarriage before lifting. achine horizontal. ine when it is raised. When lifting, keep the m Never go under the mach Never try to lift the machi ne in any posture other than the p osture given in the pr ocedure below or usi ng lifting equipment other than in the procedure be low.
e machine may lose its balance. There is a hazard that th NOTICE chine weight, see the section of "SPECIFICATIONS (PAGE 5-2)". lies to machines with standard specifications. For the details on the ma chine weight, see the section of "SPECIFICATIONS (P The lifting procedure app lies to machines with standard s pecifications The method of lifting diff ers according to the attachments and options actually installed. In such c ases, please contact your Komatsu distributor for i nformation. When lifting the machine , carry out the operation on fl at ground a s follow 1.
Start the engine, then swing the upper structure so that the work equipment is at sprocket (1) end with the track frame and upper structure set parallel. 2. Extend the bucket cylinder and arm cylinder fully, then lowe the work equipment to the ground as shown in the diagram on the right using the boom cylinder. 3. Lower the blade to the ground. (Only machines with blade specification) 1. Start the engine, the n swing the upper structure so that the work equipment is at sprocket (1) end with the trac k frame and upper structure set p arallel. ylinder and arm cylinder fully, then lowe 2. Extend the bucket c the work equipment t o the ground as shown in the diagram on the right using the bo 3.
4. Operate the work eq uipment lock lever to the LOC K position. 5. Stop the engine, che ck that there is nothing aroun d the operator's co mpartment, then g Close the cab door a nd front glass securely.