. MAINTENANCE MAINTENANCE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST Adjustment position with bolt (5). 6. Install fan guard (1). 4 - 59 Checking I f deflection amount "a" show s 10 to 12 mm (0.4 to 0.5 in) when the belt is pressed with a finger of approx. 58.8 N (6 kgf) force at the midpoint between the fan pu lley and compressor pulley, then i t is the standard deflection amo unt. P P repare a wooden block. 1. 2. Loosen bolts (2) and (3) 3. Loosen nut (4), then tight en bolt (5) so that the deflection of the belt is 10 to 12 mm (0.4 t 58.8 N (approx. 6 kgf)). 4. 5. Tighten bolts (2) and (3) Loosen bolt (5) 2 to 3 tur to secure compressor (6) in position.
ns, then tighten nut (4) and secure in NOTICE C heck each pulley for dama ge, wear of the V-groove, and wear of the V b -belt. In particular, be sure t o check that the V-belt is not touching the ottom of the V-groove. I n case any of the following o ccurs, ask the Komatsu distributor in y our t erritory to replace the belts with new ones. , leaving little allowance for adjustment. the belt. is heard coming from the belt. eadjust it after one hour of operation. • The fan belt has elongated , leaving little allowance for adjustmen • A cut or crack is found on • Slipping or creaking sound When the new V-belt is set, r