. OPERATION OPERATION below, use a bulldozer to speed. speed. 3 - 103 (A): Manual act Use this wh en operating on soft ground or in places where the t ires may sli Cancel the d ifferential lock when operating REMARK If the tires slip o r there is a difference in the ro tating speed of the tir es when th e inter-axle differential lock switc h is at AUTO, the in ter-axle differential lock is auto matically actuated to set to condition (A). (B): Manual act uation of inter-axle differential lock, and actuation o f center, re ar axle left and right di fferential l ock Use this sett ing when traveling in (A) and t he machine gets stuc k or the tire s start to s lip on soft g round .
Depress the differential l canceled. differential lock pedal at the s ame time as actuatin g the left an d right diff erential loc k switch. The ock will be actuated only while the pedal is being depressed. When the pedal is released, it is depressed. REMARK If the tires sli p or there is a difference in the rotating speed of the tires when the inter-ax le different ial lock switch is at AUTO, the inter-axle differential lock i s automatically actua ted to set to condition (B). When the le ft and right differential lock is a ctuated, the steering wheel will b ecome mo re difficult t o operate , so be particular ly careful when traveling aroun d sharp curves. (C):
Manual act uation of inter-axle differential lock, and actuation of front, cent er, rear axl e left and rig ht differential lock en the maximum rim pull is needed. Use this wh en the maximum rim pull is nee REMARK If the tires sli p or there is a difference in the rotating speed of the tires when the inter-ax le different ial lock switch is at AUTO, the inter-axle differential lock i s automatically actua ted to set to condition (C). When the le ft and right differential lock is a ctuated, the steering wheel will b ecome mo re difficult t o operate , so be particular ly careful when traveling aroun d sharp curves. WHEN TIRES ARE STUCK IN GROUND m spinning, do as follows.
If the wheels ge t stuck, to stop the wheels fro m spinning, do as foll If it is impossib le to get the machine out even when repeating the procedure machine out. ow the e accelerator pedal to stop the wheels from spinnin g. ifferential locks. inter-axle differential lock and all the left and right d ifferential l e left and right differential lock pedal, set to the gea rshift lever t o position "5", and rai se the engine e accelerator pedal and brake pedal. e accelerator pedal and brake e left and right differential lock p edal, set to the gear shift lever to position " R1", and rai se the engine ps 1 - 5 to move the machine backwards and forwards until it can escape.
ps 1 - 5 to move the machine backwards and forwa rds until it c an escape