. OPERATION TRANSPORTATION METHOD OF LIFTING MACHINE WARNING Never try to lift the machine in any posture other than the posture given in the procedure below or using lifting equipment other than in the procedure below. There is a hazard that the machine may lose its balance. 3 - 118 When lifting the machine at a port or any other place, always use the following procedure t o lift it. The operator carrying out the l ifting operation using a crane mus t be a properl y qualified crane operato Never raise the machine with a Always make sure that the wir e rope is of ample strength for the weig ht of this machine.
When lifting, keep the machine Before starting the lifting oper ation, always stop the engine, appl y the parking brake, and use the a rticulation lock to prevent he front frame from articulatin Never enter the area around or NOTICE he standard specification machine. rding to the attachments and options installed. Thi s method of lifting applies to t he standard specification machine The method of lifting differs acco rding to the attachments and options in For details of the procedure for m achines that are not the standard specification, please consult your Komatsu distributor.
Fo r the weight of the standard specification machine, see "WEIGHT TABLE (PAGE 3-119) NOTICE Use protectors to prevent the wire rope from being cut on sharp corners and to prevent the wire r ope from cutting into the machine bodywork. lect an ample width to prevent contact with the machine. When using a spreader bar, se lect an ample width to prevent contact with the Please consult your Komatsu distributor before carrying out l iftin