. MAINTENANCE SERVICE PROCEDURE CHECK OF INFLATION PRESSURE OF TIRES AND INFLATION OF THEM WARNING NOTICE If the tires are used when the inflation pressure is less than the value given in the table above, the rim may be damaged. Always keep the tire inflation pressure within +0 to +0.03 MPa (0.3 kg/cm 2 , 4.3 PSI) of the value in the table above. 4 - 37 When inf lating the ti re, check that no o ne can enter the area ar ound the tire, and always use an air chuck with a clip that can be fixed to the air valve. While infl ating the tir e, check the inflatio n pressure occasional ly so t hat it will not rise too hi gh.
If the rim is not fitted normally, it may be broken and scattered while the tire is inf lated. Accordingly, place a gu ard around the tire an d do not work in f ront of the r im but work on the tread side of the tire. f the rim Abnorma l drop of i nflation pressure a nd abnormal fitting o rim indicate a trouble in the tire or rim. In this case, be sure to ask a tire repair sh op for repai r. he specified inflation pressure. flation pressure of the tires just after high-speed work. Be sure t o observe t he specified inflati Do not a djust the in flation pressure of work.
travel or heavy-load Check Measure t he inflation pressure with a tire pressure gauge , whil e the tires are cool, before s Inflation of t ires inflation pressure properly. Adjust the inflation p ressure properly. When infla ting a tire, use an air chuck which can be fixed to th e air valve of the tire as sho wn in the figure. Do not work in fro nt of the ri m but work on th e tread side of the ti The prope r inflation pressure is show Tire size Inflation pressure [MPa (kg/cm2, PSI)] 29.5-R25 VLT (standard) 29.5-R25 VKT (standard) 0.37 (3.8, 54.0) 29.5-R25 XADT (standard) 0.39 (4.0, 56.8) 29.5-R25 RL2+ (standard) 0.40 (4.1, 58.2) 875/65 R29 (if equipped) 0.44 (4.5, 63.9)