Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK ALTERNATOR BELT TENSION, ADJUST pressed ADJUSTING 4 - 49 CHECKING The deflection shoul d be 13 to 16 mm ( 0.5 to 0.6 in) w midway between the drive pulley and a lternator pulley with the thumb with a force of 98.1 N (1 0 kg). 1. Remove cover m ounting bolts (6) ( cover. 2. Loosen bolts and nuts (1), (2) and (5 ), then turn nut ( the tension of the 3. After adjusting, ti ghten bolts and nu ts (1), (2) and (5 alternator (3). 4. Reinstall the cov er removed in step 1. Confirm tha the cover touche s any moving part of the alternato REMARK Check each pulley for breakage and wear of the V-g roove.

In particular, check that the V -belt does not touch the bottom of the V-gr oove. is found, ask your Komatsu distributor for replacement of the pulley. engthened that it cannot be adjusted any more or if it has any cuts or cracks, replace it. If any abnormality is found, ask your Komatsu distri butor for replacement of the pulley. If the V-belt is so l engthened that it c annot be adjus ted any more or if it has any cuts o When adjusting th e V-belt, do not pr ess the alternat or directly with a bar, but put a woo d piece, etc. in-between them. If the V-belt has b een replaced with a new part, there will be initial e longation, so inspect and adjust it again after one-hour of opera tion.