Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE LUBRICATE CAB MOUNT PIN (LEFT AND RIGHT: 1 PLACE EACH) pump in grease through the grease Carry out the greasing operation every day when operating in places where the grease flows out easily, such as when traveling through mud or water. CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING that the TOP casting mark is at the top 4 - 57 9. When installing, tig hten until the packing surface contacts the seal surface of the fi lter holder, then tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will l ead to leakage of fuel.

If the filter cartridge is too loose, fuel will also leak from the packing, so always tighten t he correct amount. e the filter. curely. When tightening with a filter wrench, be extremely careful not to dent or damag 10. Check that the drai n plug at the bottom of the water separator cup is tightened se Tightening torque: 0.2 to 0.45 Nm (0.02 to 0.046 kgm, 0.1 to 0.3 lbft) 11. After replacing the f uel main filter cartridge (at intervals of 1,000 hours), bleed air. For details, see "REPLACE FUEL MAIN FILTE R CARTRIDGE (PAGE 4-63)". Do not add fuel to the fuel mai n filter cartridge, however. 12.

Start the engine, ch eck that there is no leakage of fuel from the filter seal surface or water separator mounting surface, then run fo r approx. 10 minutes at low idling. 1. Stop the engine. 2. Using a grease pu fittings shown by ar 3. After greasing, wip The parts and oil are at high temperature immediately after the engine is stopped, and may ca use serious burns. Wait for the temperature to go dow n before starting the operation. remaining inside the case, the oil or plug may fly out. to release the pressure. If there is still pressure Loosen the plug slowly 1. Stop the machine s and drain plug (P) i 2. Remove plug (G) an of the plug hole. 3. If the oil level is too oil overflows. 4.

Repeat the procedu add oil to all the fin