Komatsu — EVERY 4000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN HYDRAULIC TANK WARNING the engine is stopped, and may cause burns. Wait for the NOTICE Do not use air pressure or oil pressure to carry out high-pressure greasing. CHECK ALTERNATOR, STARTING MOTOR your Komatsu distributor for inspection or CHECK WATER PUMP Check around the water pump for water leakage. If any part is leaking, ask your Komatsu distributor for inspection/repair. CHECK AIR COMPRESSOR Ask your Komatsu distributor to carry out this work.

4 - 82 EVERY 4000 HOURS Maintenance for every 5 0, 250, 500, 1000 and 2000 hours service should be carried out at th The parts and oil are at high temperature immediatel temperature to go down When removing the oil fil ler cap, turn it slowly to release the inte Refill capacity: 180 lite 1. Lower the dump bod y and stop the engine. iller (F) to release the internal pressure cap. et any oil on you, remove drain plug (P), ten the plug again. amount of engine oil from oil filler (F). 2. Turn the cap of oil f before removing the 3. Taking care not to g drain the oil, then tigh 4. Pour in the specified amount of engine oil from o il filler ( 5.

After adding oil, chec k that the oil is at the specified lev el. For details of the oil t HYDRAULIC TANK, o use, see "CHECK OIL LEVEL IN ADD OIL (PAGE 3-74)". LUBRICATE FAN PUL LEY p, pump in grease through the grease ws. 1. Stop the engine. 2. Using a grease pum fittings shown by arro 3. After greasing, wipe 1. Stop the engine. off any old grease that was pushed out. The brush may be worn repair. If the engine is started fre quently, carry out inspectio n every 1000