Komatsu — CAUTIONS WHEN USING REAR VIEW MONITOR

. ATTACHMENTS, OPTIONS USE OF REAR VIEW MONITOR SETTING OF REAR VIEW MONITOR CAUTIONS WHEN USING REAR VIEW MONITOR WARNING 6 - 39 HOW TO SET DISPLAY MODE A mark of "CAM1", "DI M", "IRIS" and "ZOOM" appears on the upper left side of the mon itor display, depen ding on the sort of ongoing ope ration. off in approx. 2 seconds after it lights up (2- second display mode). Every mark is set to go off in approx. 2 seconds after it lig hts up (2- second display mo The display can be cha nged to a constantly lighted conditi on by the following method ( continuous display mode). 1. Press mark switch same time. A "Cam1" mark lig display, and the d display mode. 2.

When it is required press mark switch same time, the sam After a "Cam1" mar the upper left sid disappears, and th display mode. REMARK 1. Press mark switch (2) while pressing manual switch (1 hts up on the upper left side of the isplay mode changes to the con to return to the 2- second display 2. When it is required (2), while pressing manual switch (1 e way as in step 1 above. k remains lighted for approx. 2 seco In either case of the 2- second display mode and continuo us display mode, the display r emains lighted all t he time in the remaining time a fter the mark goes off and before th e monitor display goes off, to o. Do not attempt to disa ssemble or modify the monitor.

There is a danger of electric shock or fire . Do not attempt to open the monitor backside cover. There is a danger of electric shock, as hig h voltage power is co nducted internally. Do not use the monitor if it is suspected of defect. There is a fea r of electric shock or fire, should it be used in spite of a defect. In that case, ask your Komatsu distributor for repair or replace ment. In case a foreign mater ial has got into the monitor or it gets wet , or if a smoke comes out of the m onitor or it gives a ba d smell, stop the use immediate Komatsu distributor. ly. It poses a big danger to use the monit or when any such abnormality ex ists.

In that case, cons ult your , be sure to use one with the specified capacity of 3A. Should a fuse with a higher- than- specified n cause fire. When replacing a fuse capacity be used, it ca As a general rule, t his product should be replaced aft er a total usage time of app g to usage conditions. roximately 3000 hours (or e water out. approximately 3 yea rs), though this may differ accordin When cleaning the monitor, use dry soft cloth or wet clo th after having well wrung th If it is very dirty, use neutral detergent. Do not use thinn er or alcohol. Sometimes an imag e on the monitor display is blurred du e to the camera lens being s meared.

In that cas e, clean the camera lens with dry soft cloth or wet cloth after hav ing well wrung the water out.