. OPERATION EXPLANATION OF COMPONENTS STARTING SWITCH This switch (1) is used to start or stop the engine. 3 - 31 OFF position : At this position, the starting s witch key can be inserted or removed. When the key is turned to thi s position, all the electric circuits a re switched off and the engine stops. ON position : In this position, electric curr circuits. ent flows in the charging and lamp Keep the starting switch key at the ON position while the engine is running. When turning the starting sw itch ON or OFF, if the starting switch is held at a position betwee n ON and OFF, the controller may detect this as a problem.
If th is happens, return the starting switch to the OFF position, then ope rate it as usual to the ON position . In cold weather, if the starting switch is turned to the ON position, pre-heating is automatica lly started and the engine pre-heating pilot lamp lights up. After the pre-heating is completed , the engine pre-heati ng pilot lamp goes out. START position : This is the position to start the engine. Hold the key at this positio n while cranking. Release the key immediately after the engine has been started. The key will return to the ON position when released.
LAMP SWITCH This switch (2) lights up the h ead lamps, side clearance lamps, t ail lamps, machine monitor light ing, and rear lamps. lamps, tail lamps, real lamps, and r lighting light up up in addition to lamps at position (b) Position (a): OFF Position (b): Side clearance machine monito Position (c): Front lamps light The lamp switch can be oper ated regardless of the position of t he lever. TURN SIGNAL LEVER rn signal lamp. forward ack This lever (2) operates the tu (a)Right turn: Push the lever (b)Left turn: Push the lever b When the lever is operated, t he turn signal pilot lamp also flashes. The lever is automatically r eturned when the steering wheel turned back. If the lever does