. OPERATION EXPLANATION OF COMPONENTS 3 - 42 ACCELERATOR P This pe dal (2) is u sed to adju st the It can b e operated freely between t he e ngine low idle position and the full throttle pos GEAR SHIFT LEVE The ge ar range c travel c onditions. Positio n D: used when traveling normally. When this position is used, This is ormally. ition is used, the tra nsmission is set automatically between the 2nd torque conver ter drive an d 6th gear according to the travel speed. While the du mp body is r aised, however, the transmission i s fixed to the 2nd ge ar and is no t changed. Keep the dump body lo wered during travel. The maxim um travel speed in this position is 58.5 km/h spee (36.4 M PH).
REMAR K In conformity with t he EU safe ty rule (EN474-6 5.1.3), the gear shift lever is restricted t o the 2nd speed and cannot be sh ifted in the D positio n, when the machine i s running while the dum p body is not fully lo wered to its seat. Positio n R1: This is used when traveling in reverse. When this po sition is used , the transmission is fixed in R1 and the trav el is carried out in torqu e converte r drive or direct drive acc ording to the travel speed. The maxim um travel speed in this positio n is 7.4 km/ h (4.6 MPH ). Positio This is used when traveling in reverse.
When this po sition is used , the transmission is fixed in R2 and the trav el is carried out in torqu e converte r drive or direct drive acc ording to the travel speed. The maxim um travel speed in this positio n is 17.5 km /h (10.9 M PH). The ma chine cann ot travel in reverse w hile the dump body is raise d. Lower the dump body a nd set the dump l ever in the " FLOAT" po sition, and then set i t in the "R1" o r "R2" position