43.3 General Instructions for Laying and Fabricating Metal Piping: Piping when laid must not be subject to stresses of chafing and must be fixed at the same mounting points as the line removed. A pipe bender should be used for bending purposes. Refer to line removed for shape. On no account must pipeline be heated for bending because surface protection will be destroyed and oxidation will cause brake unit trouble. Each pipe end must be cut off at right angles and deburred. Slide cap nut, cutting and thrust rings onto pipe end and couple to union while pressing pipe into position. Pipe must not be allowed to turn.
Then release cap nut again to check whether cutting edge of cutting ring has penetrated pipe surface and whether visible bead has been produced by the cutting edge. Prior to final installation, the piping must be cleaned with compressed air. Instructions for Installing Plastic Piping: 1 Material: Plasticpiping is made of polyamide 11 - 12 w LT. Polyamide is flexible and resists all fluids, oils and greases used in motor vehicles. In addition, plastic piping is also resistant to bases, unchlorinated solvents, organic and inorganic acids and diluted oxidants. The melting point of plastic piping is ч 1 86 ° C, temperature be tween -40 ° and + 1 000 C being perfectly safe.
When performing drilling and welding operations, protect or remove plastic piping. 2 Coupling and Fitting: Plastic pipe 1 should be cut off at right angles for each new joint. Then slip sleeve insert 2 fully home into pipe end and position cap nut 3 and cutting ring 4 on plastic pipe. Now hand-tighten cap nut until appreciable resistance is felt at union 5. Tighten 11/2 to 13/4 more turns using wrench. Release cap nut and check whether cutting ring is seated firmly in plastic pipe and also whether a slight bulge has appeared in front of cutting ring. Then tighten cap nut in the normal manner. To fit a pipe union, hold plastic piping in special tool No.1. NJ