Symbols for Hydraulics and Pneumatics 43.3 acc. to DIN 24300 and with unit connection designations acc. to DIN 74254 - Provisional Edition - Unit connection Designations According to DIN 74354 draft Scope This standard applies to air brakes on motor vehicles including systems with hydraulic power transmission and their trailers. The designations should be provided both on the actual units next to the connection and in the brake diagrams next to the line connections shown there. Designation The designations consist of one or two digits. The meanings of the first digit are:
O Intake connection 1 Power inflow 2 Power outflow not for outflow to atmosphere 3 Connection to atmosphere for bleeding and venting 4 Control connection input to unit A second digit must be used whenever several similar connections, e.g. for several circuits, are possible or provided. It is good practice to start the second digit at 1, e.g. 21, 22, 23 etc. Several similar connections from one chamber should be given one and the same designation. If a connection is able to perform several functions, it requires to be identified by two first digits, separated by a dash. Refer to example. Example 1-2 21 22 UZ42-0054