mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

43.3 Control Equipment Trailer Control Valve Removal and Installation 5 Reassembly is performed in the reverse sequen ce. 1 Make compressed air system pressureless. Note: Bleed trailer control line when handbrake reaches fourth detent. Adjustment is made by shorte ning or extending actuating rod between valve and handbrake intermediate lever. 2 Unscrew lines 3 off. 3 Force off actuating rod for handbrake at ball head after loosening locking clip Reference dimension for adjustment: 115 mm bet ween check nuts of actuating rod. Final adjustment depends on total of tolerances! 4 Unscrew valve on bracket and remove. .43 6 Check system for leaks. Dab test points with soapy water. 42 Note:

Use only new sealing rings. Disassembly, Inspection and Assembly 1 Clean valve externally P3 solution, compressed air. 2 Remove cotter pin on castle nut handbrake lever end and loosen castle nut. 3 Remove running ring with balls. 4 Remove lever. 5 Unscrew four hexagon bolts on housing and remove cover. Note: Caution, cover is under spring pressure. 6 Remove spring. 7 Remove cap screw. For this purpose, remove cotter pin, washer and bolt. UZ 43-0064 8 Remove large diaphragm disk, loosen locking ring, remove small diaphragm disk and remove cup sleeve. Air-Controlled Trailer Control Valve 1 Housing 24 Locking ring 21 x 1.2 2-3 Valve, compl.

25 Diaphragm disk 3 Cap 26 Cap screw 4 0-ring 292 x3 27 Bolt6h 11 x35x27 5 Compression spring * 28 Washer 6.4 9 Unscrew exposed socket head bolts.