Picture 55-6/3 2 Sealing ring* 1 Gear type oil pump, compl. 11 = Sealing ring* A 22x27 12 = Locking screw 22 = Lock ring 6 23 = Hex, nut M 6 24 = Gasket* 3 = Ball" 8 III 4-33 = Pump mounting compl. 4-10 = Crankcase, compl. 4 = Crankcase, compl. 14 = Bushing 15-16 = Dip stick, compl. 13 = Sealing ring’ A 18x22 25 = Cover 26 = Lock ring 10 27 = Hex, nut M 10 28 = Key 5X7.5 29 = Lock ring A 18 30 = Hex, nut M 18X1.5 5 = Stud bolt M 6x13 16 = 0-ring 17 = Shaft, compl. 6 Stud bolt M 10X20 7 = Stud bolt M 10X22 19 = Sealing ring* 18 = Grooved ball bearing 25x62X17 9 = Stud bolt M 8X35 10 = Stud bolt M 8X75 8 = Breather screw 20-21 = Cover compl.
20 = Cover 31 = Washer 32 = Lock ring 8 33 = Hex, nut M 8 21 = Oil seal’ B 1 25x37 * Wear and parts ** This parts should be exchanged always when repairing compressor-oil pump. When ordering parts, give designation and order number Only the positions mentioned above should be dismounted and repaired. The dismounting of the gear type driven oil pump is not permissible, auomatically, the warranty would be lost. If the pump does not function correct anymore, install an exchange pump. Always use, when changing the pump, 3 new balls pos. no. 3. The groove of the balls should not be worn out.