Cleaning cooling system 20.9 615 616 621 636 Cleaning If the cooling water starts to boil, there is a fault in the cooling system, possibly too little water or contami nation. In that case the cooling system must be degreased, defurred and cleaned. since the cleaning operation can be monitored exactly by means of a test strip supplied by the manufacturer. Precisely observe instructions for use of the hy drochrome treatment: Dissolve 13cm3 solvent in 131 water and fill in with engine running in partial quantities of respectively 1/21. After a longer trip, at least after one day, shortly immerse a test strip through the filler hole into the cooling water.
Read which pH-value the shade of the Note: When examining, above all, check the slide ring seal rubber hose from the cylinder head to the cooling water outlet, namely: 2. for contamination, 1. for cracking, test strip used corresponds to the colour scale supplied together with test instructions and test 3. for lime deposits. strips from manufacturer. If this amounts to more than The free passage through the hose is checked by releasing on one side while observing the escape of water. six, drain cooling water, once again thoroughly flush out cooling system and repeat the procedure. The cleaning is concluded, if after a longer trip, the pH- value remains under six.
Then once again drain Degreasing: coaling water, thoroughly flush out cooling system and trat the filled cooling water according to instruc Fill in two handfulls of soda, PS or IMI into the cooling system at the cooling water inlet. Drive one day with this additive, then again drain solution. Thoroughly flush through cooling system with engine running with simultaneous flow of fresh water. tions for use. Cleaning: Blow out radiator from engine side with compressed air or spray with water so that the radiator fins are thoroughly clean of foreign bodies. Check rubber hose connection between radiator and pipeline for leaks and exchange if cracked or brittle.
Remove and thoroughly clean thermostat. Defurring: We recommend urgently that the defurring be execu ted only in a customer sevice centre. Defurring is best performed by means of a hydrochrome treatment Under no circumstances use hydrochloric acid solution for cleaning!