General 42.3 Faults and remedy Hydraulic system drum brake Faults Cause Remedy Ce, but can be fully depressed fur ther and spongy. Too little fluid supply in the reser- Supplement and bleed brake voir. fluid. Brake footpedal offers no resistan- Air in the system. Bleed, if possible with bleeder. Adjust wheel brake before blee ding brakes. Braking action only after repeated Wheel brake not adjusted. Adjust wheel brake. depressing of the brake footpedal. Air in the system. Bleed. The brake weakens and the brake Leaking lines damaged or unusable The line must be sealed, damaged footpedal can be depressed fully sleeves in main or wheel brake sleeves are to be replaced.
short time after adjusting. cylinder. Brake heat up during use. Compensating bore in the master Clean compensating bore of the brake cylinder clogged, master brake cylinder. Too little clearance between brake Adjust brake footpedal. footpedal and master brake cylinder piston. Brake shoes - return springs weak. Install yew return springs. Rubber parts swollen from use of Drain fluid, remove all rubber improper fluids. parts, flush installation through well with metholated spirits, in stall new rubber parts including bottom valve and valve seat ring. Brake tightens itself. Compensating bore in the master Clean compensating bore with a brake cylinder is clogged.
This can 0.5 mm fine wire, flush brake line happen due to swollen sleeve. Use through well with metholated spi of improper fluid or variation of the rits, insert new sleeve, fill with brake foot pedal stop. brake fluid, Check and correctly adjust stop of the brake footpedal so that the compensating bore is freely in the idle condition of the brake.