Bleeding Brake System 42.3 Instructions for Bleeding The brake system must be bled after any repair job that has involved opening the sealed hydraulic system, or when the brake pedal feels soft and spongy. A variety of special-purpose equipment, e. g. the ARC 50 unit or the ATE filler/bleeder, are commercially available for this purpose. Follow the instructions supplied with this equipment. Do not re-use fluid that has been pumped out when bleeding because it may contain foreign matter which will then enter the brake system. In addition, brake fluid, being highly hygroscopic, ‘steadily absorbs moisture from the atmosphere and its boiling point drops during service life.
As a result, vapour bubbles may form in the brake system under extreme conditions. Brake fluid contains constituents which will dissolve paint. Ensure that brake fluid is kept well away from the vehicle paintwork. When bleeding the system, ensure that the bottom of the refilling container is always covered by brake fluid. On no account may the compensating port be free of fluid because air will otherwise be drawn in when the brake pedal is pressed, rendering the entire bleeding operation futile. Also ensure that the bleeder vessel is held high enough so that the level in the vessel is higher than the outlet from the bleeder valve.
Bleeding is completed when bubble-free brake fluid flows through the bleeder hose. Following bleeding, top up reservoir to "Maximum" mark with brake fluid. Note: If the system is bled by "pumping" the brake pedal, remember to close the corresponding bleed screw each time before releasing the brake pedal. This ensures that air cannot be drawn in through the bleed screw hole.