mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

Replacing Brake Linings 42.3 Replacement Note: Brake linings which are oily, brittle or worn down to minimum thickness must be replaced. 1 Remove brake shoes, referring to 11.1/1. Note: Prior to selecting new brake linings repair stages, check brake drums for thermal cracking, scoring and wear, machining or replacing if necessa ry. Use a brake drum lathe in accordance with manufacturer’s instructions. Refer to Table 1.3/1 for minimum lining thickness and repair stages of brake linings as well as diameters and repair stages of brake linings. Always use brake linings of same type on any one axle. 2 Remove fastening rivets.

3 Clean, check and derust contact surfaces of brake linings on brake shoes. 4 Select brake linings to suit brake drum diameter repair stage and rivet in position. Note: It is preferable to use a rivetting machine and rivets approved for the purpose. Set up rivetting machine according to manufacturer’s instructions. Start rivetting in centre. Do not turn lining segments through 1800; thickest side of lining pointing toward centre of brake shoe. Brake lining must fit sriuggly across entire surface. Corners of linings must not be broken nor must linings be torn at rivets. 6 Install brake shoes, refer to 9.1/1. Note:

To ensure that new brake linings provide immediate effect, they must be dressed in situ on axle, refer to 11.1/1. Dressing Brake Linings on Axle Brake shoes can be dressed in situ using brake shoe turning equipment. Be sure never to exceed maximum brake drum dia meter specified; refer to 1 .3/1 for permissible brake