mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

42.3 Turning brake shoes 21 Release locking screws in the guide column bearing bracket 5, shift guide columns 6 with feed spindle 8 and steel holder 7 until the cutting tool is some mm outside the edge of brake lining. Fasten locking screws. 22 Check end cut-out by freely turning spider 16. 23 Raise feed selector fingers 13, push steel holder into starting position, again lower feed selec tor finger 13. j UR42-Ooo1f 1 24 Push back uide driver rod 12 in clamp guide 11 so far that spider 16 is still grasped. 25 Release clamp guide and adjust so that a clearance of from 2 to 3 mm exists between driver rod 12 and cut out of spider 16.

26 Place spider vertically and turn once by hand to check ease of operation. 27 Install protective cover and turn brake shoes. Note: Repeat turning if necessary until drum or turn diameter on entire brake shoe is reached and corresponding air gap is ensured. J