. OPERATION MACHINE OPERATIONS AND CONTROLS Check Coolant Level, Add Coolant WARNING 3 - 71 Checks Before Start Always check the item s in this section before sta rting the engine each Do no t open the radiato r cap unless necessary. Whe n checking the coolant, always wait for the engine to cool down and check the s ub-tank. Immediately after the e ngine is stopped, the coolan t is at a high temperatur e and the radiator i s under high internal pressure. If the cap is removed t o check the coolant level in this condition, there is a hazard of burns. Wait for the temperature to go down , then turn the ca p slowly to release the press ure and remove it c arefully. 1.
Op en the rear door at the left of the machine a nd check that the cooling water level is between the FULL an d LOW marks on radiator sub tank (1 ) (shown in the diagram on the right). If th e water level is l ow, add water through the water filler of sub tan k (1) to the FUL L level. t, tighten the cap securely. comes empty, there is probably coolan 2. Afte r adding coolan t, tighten the cap securel 3. If t he sub-tank be comes empty, there is leakage. After chec king, repair any abnormal ity immediately.
I no ound, check the level of , add COOLANT of the the water in the same densit y in radiator according to the COOLANT density table in "CLEAN INSIDE OF COO LING SYSTEM (PAGE 4-26)", then add ub-tank. add COOLANT to the s 4. If th e inside of sub- tank (1) is dirty and the w ater level canno be seen, use the pr SYSTEM (PAGE 4 ocedure in "CLEAN INSIDE OF COOLING -26)".