Komatsu — Komatsu PC308USLC-3E0 Hydraulic Excavator Operation & Maintenance Manual

. OPERATION MACHINE OPERATIONS AND CONTROLS REMARK If transparent cap (2) is dirty or it is difficult to see the inside, clean transparent cap (2) when replacing fuel pre-filter cartridge (1). When the drain valve (4) has been removed during the cleaning operation, coat the O-ring with grease and tighten until it contacts the bottom. 3 - 74 Drain Water And Sediment f rom Fuel Tank e right of the machine. 1. Open the rear door at th 2. Set a container under th it is drained. 3. Open drain valve (1) accumulated at the bott 4. When no more water a close drain valve (1). 5. Close the door at the m 1.

Open the rear door at th e drain valve (1) to catch the fuel when and drain the water and sediment om together with the fuel. nd sediment comes out with the fuel, achine's right rear. Check for Water and Sediment in Water Separator, Drain Water 1. Open the rear door at th The water separator 2. It is possible to judge th by looking through trans sediment collected at th drain water under drain 3. Loosen drain valve (4) a 4. When fuel starts to dra valve (4) immediately. 1. Open the rear door at th e water level and amount of sediment parent cap (2). If there is any water or e bottom, set a container to catch the hose (3). nd drain the water.

in from drain hose (3), tighten drain On this machine, a sens or is installed to detect if water is cap (2). accumulated in transparent When the water separator m onitor (5) lights up red on the machine monitor, it indicates that wa (2). In this case also, use the pr ter is accumulated in transparent cap ocedure above to drain the water. cap NOTICE If the water accumulated in transparent cap (2) freezes, the water separator monitor may not light up. After the engine is t up. After the engine is started, as the temperature a suddenly light up.

In cold a round fuel pre-filter (1) increases, the froze n water will melt and the wat er separator monitor may reas, even if the water separator monit or does not light up, drain the wa ter frequently. If the water inside transparen t cap (2) freezes, check that the frozen water has melted completely, then use the procedure above to drain the water.