Komatsu — Komatsu PC308USLC-3E0 Hydraulic Excavator Operation & Maintenance Manual

. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Hydraulic Tank, Add Oil WARNING temperature immediately after the engine is stopped, and may cause burns. Wait for the C (50 to 86 ° F)) C (122 to 176 ° F)) plug (P). 3 - 76 The parts and oil are at high temperature to go down before When removing the oil filler cap . Set the work equipment in t he posture shown in the diagram on the right, then check the oi l level and add oil if necessary. not in the condition shown in the the engine, run the engine at low . If the work equipment is diagram on the right, start speed, retract the arm an lower the boom, set the buc and stop the engine. .

Within 15 seconds after d bucket cylinder rods fully, then ket teeth in contact with the ground, stopping the engine, move each control lever (for work equi in all directions to release t pment and travel) to the full stroke he internal pressure. m the right window installed to the . Check sight gauge (G) fro operator's compartment. T and L lines. he oil level should be between the H . If the level is below the L m ark, add oil through oil filler (F) at the top of the hydraulic tank. REMARK The oil level will vary dependin Accordingly, use the following Before starting operation: B (Oil temperature 10 to 30°C Normal operation:

Around (Oil temperature 50 to 80°C NOTICE Do not add oil above the H line. T his will damage the hydraulic circuit or cause the oil to spurt out. the H level, swing the upper structure If oil has been refilled, exceeding until drain plug (P) beneath the hyd raulic tank comes between the right and left track shoes and stop the e ngine. Wait for the oil to cool down