. OPERATION MACHINE OPERATIONS AND CONTROLS OPERATION MACHINE OPERATIONS AND CONTROLS Ambient temperature Lighting time -4 ° C to -15 ° C (24.8 ° F to 5.0 ° F) 5 seconds to 30 seconds -15 ° C (5.0 ° F) or less 30 seconds 4. If the preheating monitor does not light up, or it lights up and then goes out to inform that the engine preheating has been completed, turn the key in starting switch (3) to the START position (C) and start the engine. REMARK If the ambient temperature is low, the engine may not start even when the key in the starting switch (3) is kept at the START position for 20 seconds. If this happens, wait for at least 2 minutes, then start again from the beginning. 5.
After the engine starts, release the key in starting switch (3). The key will automatically return to the ON position (B). REMARK When the engine is started, the battery voltage may suddenly drop depending on the temperature and the battery condition. If this happens, the display on the machine monitor may momentarily go out, but this does not indicate any abnormality. 6. Even if the engine starts, wait for the engine oil pressure monitor to go out. Do not touch the control levers or control pedal while the engine oil pressure monitor is lighted up. NOTICE If the engine oil pressure monitor does not go out even after 4 to 5 seconds have passed, stop the engine immediately.
Check the oil level, check for leakage of oil, and take the necessary action. 3 - 88 3. Turn the key i n starting s witch (3) to O N position ( B). If the ambient temperature is lo w, the p reheating m onitor lights up and automatic preheating is c arrie d out . Kee p the key in starting switch (3) at the ON position (B) until the preheating until monitor goes out. The time tha t the preheating monitor stays lighted up depends on the ambient temperature as show n in the t able on the right.