. OPERATION MACHINE OPERATIONS AND CONTROLS Inversion REMARK light NOTICE 3 - 123 1. Place the bu cket in contact w ith a flat surfac Whe contact with the g If th e bucket is lo wered strongly t o the ground, t he resistance b e increased and it will be difficul t to remove the pins. After removing the pins, make sure th at mud or s and d oes not get on t hem. Dust seals are fitted at both ends of th e bushing s, be ca reful not to damage them 2. Remove the double nut on th e stopper bolt f or arm pin (A) and ink pin (B), re move the bolt, p ull out arm pin ( A) and link pin (B), and then rem ove the bucket. 3. After removin g the bucket, re verse 4.
Align arm (5) with replaceme nt bucket hole (1), then a lign link 6) with hole ( 2), coat pins (A) and (B) with g rease, an d install.