Komatsu — Komatsu PC308USLC-3E0 Hydraulic Excavator Operation & Maintenance Manual

. OPERATION LONG TERM STORAGE LONG TERM STORAGE BEFORE STORAGE NOTICE To protect the hydraulic cylinder piston rod while in storage, keep the work equipment in the posture shown at right. (This prevents rust from developing on the piston rod) DURING STORAGE WARNING 3 - 144 When putting the machine in storage fo r a long time (more than one month), do as follows. Clean and wash all parts, then store the machine indoors. If the machine has to be stored o utdoors, se lect level ground and cover the machine with c anvas. vents moisture from collecting. storage. aulic cylinder piston rod with grease. Completely fill the fuel tank.

This pre Lubricate and change the oil before Coat the exposed portion of the hydr Disconnect the negative terminals of t he battery and cover it or remove it from the machine an d store it se parately. Lock each control lever and pedal wi th the lock lever and pedal lock. Set the stop valve to the LOCK positi on on machines ready for attachments. Install the blind plugs to the elbows. Set the selector valve on the machin es which can install attachments to the "Where no atta chment is m ounted" position. o give a density of at least 30% for the engine coolant. To prevent rust, fill with COOLANT t o give a density of at least 30% for the engine coolant.

If it is necessary to perform the rust-preventi on operation while the machine is indoors, open the doors an d windows t o improve ventilation and prevent gas poisoning. During storage, operate and move th e machine for a short distance once a month so that a n ew film of oil will coat moving parts. At the same time, als o charge the battery. If the machine is equipped with an ai r conditioner, operate the air conditioner for 3 to 5 minu tes once a month to lubricateall parts of the air conditioner check the refrigerant level twice a ye compressor. Always run the engine at low idle when d oing this. In addition, ar.

AFTER STORAGE NOTICE If the machine has been stored without car rying out the monthly rust-prevention operation, consult yo ur Komatsu d istributor before using it. When using the machine after long-ter m storage, do as follows before using it. ic cylinder rods. oints. Wipe off the grease from the hydraul Add oil and grease at all lubrication p When the machine is stored for a long period, moisture in the air will mix with the oil. Check th e oil before and after starting the engine. If there is water in the oil, change all the oil.