. OPERATION TROUBLES AND ACTIONS TROUBLES AND ACTIONS starting the engine. 3. Loosen the knob of feed pump (1), pull it out, then pump it in and out until the movement becomes heavy. REMARK more or a high when the heavy-duty 3 - 146 RUNNING OUT OF When starting the engin e again after running out of fuel, fi ll with fuel, then bleed the air fr om the fuel system before Procedure for Bleeding A ir 1. Fill the fuel tank with f highest position). 2. Open the rear door a uel (to the position where the floa t the right of the machine. It is not necessary to rem ove the plug at the top of the fuel and fuel main filter. 4. Push in the knob of f 5.
Turn the key in the s tarting switch to the START posi tion and start not crank the starting motor conti nuously for more than 20 secon ds. If the engine do es no t 2 minutes, then try again. Perfo rm this operation a maximum PHENOMENA THAT ARE NOT FAILURES Note that the following phenomena are not failures: Note that the following p When the arm control lever is operated to the IN position work equipment is low ered under no load from a high the arm speed will dr op momentarily when the arm is sition.
less at the vertical po When the bucket cont rol lever is operated to the CURL and the work equipm position, the bucket ent is lowered under no load fro speed will drop momentarily w bucket teeth are more or less at the horizontal position The bucket or arm digging operations. will fluctuate by itself during he When starting or stop ping the swing, noise will be emit ted from the When going down a s teep slope at low speed, a noise will be emitted from the travel