Komatsu — Komatsu PC308USLC-3E0 Hydraulic Excavator Operation & Maintenance Manual

. MAINTENANCE MAINTENANCE PROCEDURE WARNING the distilled water, see 4 - 27 COOLANT is toxic. When open th e drain valve, be careful not to get coolant on you. . If it gets in your eyes, flush your eyes with large amount of fresh water and see a doctor at once When changing the coolant or wh en handling the coolant containing COOLANT that has been drai ned during repair of radiator, please contact your Komatsu dis tributor or request a specialist compan y to carry out the operatio n. COOLANT is toxic. Do not let it flow into drainage ditches o r spray it onto the ground surface. COOLANT is already diluted w ith distilled water, so it is not flammable.

(For details o "COOLANT AND WATER FOR DILUTION (PAGE 4-5)"). Check t he density with a COO Prepare a container whose cap acity is larger than the specified coolant volume to catch Prepare a hose to use when filli ng with coolant. 1. Stop the machine on level ground, then stop the engine. 2. Check that the coolant temp erature has gone down enough to make it possible to touch t then turn radiator cap (1) slo release the pressure. he radiator cap surface by hand, wly until it contacts the stopper to 3. Following this, push radiator stopper, then remove it. cap (1), turn it until it contacts the 4.

Remove the cover (2), then set the container under drain valve (3) to catch the coolant mixt Open drain valve (3) at the b coolant. ure. ottom of the radiator and drain the 5. After draining the coolant, cl water. When the radiator is f ose drain valve (3), and fill with city ull, start the engine and run at low idling to raise the temperat continue to run for approx. 1 6. Stop the engine and open d ure to at least 90°C (194°F), then 0 minutes. rain valve (3) to drain the water. an the radiator with detergent. low the instruction of detergent. 7. After draining the water, cle For the cleaning method, fol 8. Close drain valve (3). 9. Install cover (2). 10.

Add coolant through the wa ter filler port up to the mouth of the port. For details of th e COOLANT density, see "COOLANT DENSITY TAB LE". 11. Run the engine at low idling for 5 minutes to remove the air fro m the water, then run a t high idling for 5 minutes. (Leave radiator cap (1) rem oved when doing this.)