. MAINTENANCE MAINTENANCE PROCEDURE the oil inside the travel motor case has at low idling, loosen air bleeder (1), and 4 - 39 NOTICE If the air is not bled from the swing motor, the motor bea rings ma y be When replacing the trave l motor safety valve, p lease con tact your Komatsu distributor to have it r eplaced and to have the air bled. 5. Bleeding air from tra (Bleed bee 1) check that oil flo 2) Run the engine a t low idle and swin g the wor k equipment 90° to bring it to t he side of the track . is raised slightly from 3) Jack up the mac hine until the track from the ground.Rotat e the track under n o load for 2 minutes.
Repeat this proce dure on both the le ft and rig ht sides, and rotate the track e qually both forward and in re verse. 6. Bleeding air from atta f a breaker or other a ttachment has bee n installe d, run th e engine at low idle and opera te the attachment peda epeatedly (approx. 1 0 times) until the ai r has be en bled from the NOTICE If the method of bleeding the air from the attachment its elf is specifie d by the manufacturer, ble ed the air according to the specified procedure. After completing the air b leeding operation, st op the eng ine, and leave the machine for 5 minutes before starting operations. This will remove the air b ubbles in the oil insid e the hydr aulic cylinder s.
spilled. the oil level is low, add oil. Chec k that there is no lea kage of oil and wipe off any oil that has been After completing the air b leeding operation, in spect the oil level, and if the oil level is low, add oil.