. MAINTENANCE MAINTENANCE PROCEDURE CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS,FUEL COOLER FINS, AND AIR CONDITIONER CONDENSER FINS WARNING conditioner Blow them water may be sufficient of the heat will cause (4) into the 4 - 52 If compressed air, high-pr essure water, or steam hits your b ody directly or dirt is sent flying by the com pressed air, high-pressure wate r, or steam, there is d anger of personal injury. Always wear protective glasses, dust mask, and o ther protective equipment. NOTICE Whe n using compressed a ir for cleaning, blow it keeping so me distance to avoid damaging the fins. Da mage on the fins can cause wate r leakage and overhe ating.
In a dusty job site, check th e fins every day, regardless of the mainte nance interval. 1. Open the engine h ood. 2. Loosen screws (1) (located at 6 spots) to pull up (2), (3) and (4). 3. After pulling up, cle an each of nets (2), (3) and (4 4. Inspect the front an d rear of radiator fins (5), oil c after-cooler fins (7 ), fuel cooler fins (8) and ai for dirt, dust, dry leaves, etc condenser fins (9) away with com-pr used instead of co essed air, if any. Steam or w mpressed air.
However, when powerful steam cle aning (high-pressure machine heat exchange equ ipment (radiator, oil cooler, aft cooler, and air co distance from the m nditioner condenser), maint achine when carrying out the steam cleaning (hig h-pressure machine wash) is close range, there is danger that the internal fin exchange equipm ent may be deformed, and th breakage. early clogging and 5. Check the rubber h ose. Replace with a new one found to have crac ks or to be hardened by aging check the hose cla mps for looseness. ert each of nets (2), (3) and 6. After cleaning, ins original position an d then fasten them with screw