. MAINTENANCE MAINTENANCE PROCEDURE METHOD OF RELEASING PRESSURE IN HYDRAULIC CIRCUIT 4 - 69 1. Plac e the wo rk equipment o n the ground. Cl ose the crusher 2. Operate the work equipmen t lock lever to th e LOCK position. 3. Inse rt the loc k pin for the at tachment contro l pedal i n position (c) w here it is possible to op erate the pedal. (If e Carry ou t Steps 4 - 6 within 15 When th e engine is stopped, the pressure in the a ccumulator gradually goes down. For this r eason, the release can only be carried o ut immediately after the engine is stopped. 4. Stop the engi ne. 5. Turn the start ing switch to t he ON position ( 6.
Set lock leve r to FREE po sition (F), then d the attachmen , t hen operate the work equipment co ntrol levers an t contro l peda l (i equipped) ful ly to the front, rear, left, and right to release the it. lease the pressure in th e control circu 7. Set the lock l ever to the LO CK position , the n turn th e starting switch to the OFF positio 8. Inse rt the lock pin in position (a) so that the a ttachme nt contro ped al cannot (If e