. OPERATION EXPLANATION OF COMPONENTS preferred air flow, to prevent dust from entering the cab. PRECAUTIONS WHEN USING AIR CONDITIONER 3 - 71 AIR CONDITIONER SWI TCH This switch (5) is used to switch the air conditioner ON/OF REMARK For machines equippe d with a heater only , switch (5 ) is not available. (Opti OFF SWITCH Switch (6) is used to st op operation of the fan. REMARK When fresh air is tak en into the cab, air pressure in the cab Whe pressu increases, which prev ents the dust from entering.
When neither heating nor cooling is needed, bring in clean f resh air, wit WHEN CARRYING OUT COOLING, VENTILATE THE CAB FROM TIME TO TIM E If you smoke when u sing the air conditioner, your eyes m ay start to i tch or burn, therefore ventilat e the cab every so often to remove the smoke. oner is used for long periods, carry out ventilation once every hour. When the air conditi oner is used for lon g periods, carry o ut ventilation on ce every h BE CAREFUL NOT TO COOL TOO MUCH th, it is recommended that the cab should feel pleasantly cool when you enter it from the F or reasons of heal th, it is recommended nter outside (5 to 6°C (9 .0 to 10.8°F) lower than the outside temperature).
Pay attention to the temperature when perature when carrying out cooling. SET SO THAT COLD AIR DOES NOT DIRECTLY BLOW ONTO THE GLASS SURFACE If the vents (left and right) in the middle o f the dashboard are turned so tha t cold air p lays directly on the ca b door glass, moisture may condense on the outside of the cab door glass and reduce the visibility. (This occurs mperatures.) the vent fully to the rear and raise the air conditioner temperature setting slightly. the visibilit ccurs particularly in high te If this happens, turn the vent fully to the rear and raise th e air conditioner temperature s etting sli