. OPERATION OPERATION RIPPER OPERATION EFFECTIVE METHOD OF USE rear. 3 - 129 The op timum digging a ngle for the shank is when the shank is dicular to the gr ound (ripping angle: 45 In com paratively soft ro ck (seismic velocity: 1 500 m/s or below), o possible to ca rry out ripping with the shank tilted to the On co mparatively har d rock, if ripping is ca rried out with the shank of tip ( tilted to the rear, there will be excessive wear of the point 1), and the self-s harpening ability will b e lost. During ripping operatio ns, if the shoes slip be cause of boulders or resi When speed stance from the bedrock, use the tilt cy linder.
picking up a sto ne, advance the machi ne at a fixed gear (F1 or F2). REMARK raising boulders or digging up rockbed, do not put the transmission in neutral. If the transmission is in When neutra transm l, the reaction of the tilt cylinder will push the machine back. Always operate the machine with the ARD. ission in FORW Choos ing a suitable rip per point to match the t ype of rock is one of the most i mportant elem ents in using the ripper effecti Rippe details vely. r points are avai lable for different types of rock, so select the most suitable ripper point from the li st. For , see "PROCED URE FOR SELECTIN G RIPPER POINT (PAGE 6-4)".