Komatsu — LOADING, UNLOADING WORK

. OPERATION TRANSPORTATION UNLOADING bending. and trailer, and the 3 - 145 1. Load and unload on firm level ground only. Ma intain a safe distance from the edge o 2. Apply the trailer brakes securely, then put bloc ks (1) under the tires to prevent t he trailer from moving. right ramps (2) parallel to e Set left and d to the left and right of center (3) of the trailer. of installation (4) a maximum of 15°. If the weight of the a large amount under the blocks under the ramps to pre vent them from 3. Remove the cha ins and wire ropes fastening t 4. Start the engine. Warm the engin 5. Set main work e quipment lock lever to FREE position (F), and raise the work e (When transporti quipment.

ng with work equipment installed) 6. Set parking brak e lever to the FREE position ( F). 7. Set the transmis sion in the 1st gear and run th e engine at low idle. 8. Set the travel dir ection toward the ramps and drive slowly. uddenly at the border between the ra 9. The center of gr avity of the machine shifts s border machine is unba lanced and becomes dangero us. Accordingly, pass the border slowl 10. Drive down the r amps slowly and carefully unt il the machine leaves the ramps perfec