Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE WARNING 1. Turn radiator cap (1) slowly and remove it. 4 - 23 Antifreeze is toxic. When open the drain valve, be caref ul not to get water containing antifreeze on y ou. If it gets in your eyes, flush your eyes with large amount of fresh water and se e a doctor at once. When changing the coolant or draining the coolant from the radiator before carrying out repairs, as k a specialist company to handle any coolant containing antifreeze, or contact your Komatsu distributor. Antifreeze is toxic, so never pour it into ce. drainage water ditch es or drain it onto the ground surfa The coolant is alrea dy diluted with distilled water.

(F or details of the distilled water, see "CO OLANT AND WATER FOR DILUTION (PA GE 4-6)". Check the density wit h a coolant tester. 2. Prepare for a c ontainer to receive drained s uper coolant- mixed cooling w the lower portio open drain valve ater, pull out radiator hose (2) tu cked away in n of the machine's front right side, and then (3) to drain the water. e (4) fitted to the water pump piping on the e to drain water. 3. Open drain valv engine's right sid 4. After draining the coolant, close drain valves (3) a nd (4), and fill with city water. 5. When the radiat or is filled with water, start the engine, run at ° low idling, raise run the engine fo 6.

Stop the engine the water temperature to at least 90 C, then r approx. 10 minutes. and open drain valves (3), (4) to drain the water. 7. After draining the agent. For the cleaning agent. water, clean the cooling system with cleaning method, see the instructions fo r the cleaning 8. Close drain valv e (3)(4) and add Supercoolant t o near the mouth of the water filler. COOLANT DENSITY TABLE. For details of the Supercoolant density, see the 9. To bleed the air mixed in the coolant, run the en gine at low idling for 5 minutes, then run for a further 5 minutes at high idling. (When doing thi s, leave the water filler cap off.)