. MAINTENANCE SERVICE PROCEDURE EVERY 250 HOURS SERVICE (4) Brace screw (2 places) (single tilt specification) 4 - 51 LUBRICATIN 1. Lowe r the work e quipment to the ground, then stop the engine. 2. Using a g rease p ump, pump i n grease through the grease 3. After greasing, wi pe off any o ld grease that wa s pushed out. (1) Blade lift c ylinder support yok e (4 places) REMARK These are at the front and rear of the left and right cylinders (2) Blade lift c ylinder support shaf t (2 places) SIGMADOZER (3) Blade arm ball join (4) Brace screw (2 pla ces) (single tilt specification) SEM (3) I U-DOZER Blade arm , U-DOZE ball join R t (4 places)