. SAFETY PRECAUTIONS FOR OPERATION SAFETY PRECAUTIONS FOR OPERATION the LOADING AND UNLOADING When loading or unloading the machine, mistaken operation may bring the hazard of the machine tipping over or falling, so particular care is necessary. Always do as follows. Perform loading and unloading on firm, level ground only. Maintain a safe distance from the edge of the road or cliff. Always use ramps of adequate strength. Be sure that the ramps are wide, long, and thick enough to provide a safe loading slope. Take suitable steps to prevent the ramps from moving out of position or coming off. Be sure the ramp surface is clean and free of grease, oil, ice and loose materials.
Remove dirt from machine-tracks. On a rainy day, in particular, be extremely careful since the ramp surface is slippery. Run the engine at low idling and drive the machine slowly at low speed. When on the ramps, do not operate any lever except for the travel lever. Never correct your steering on the ramps. If necessary, drive off the ramps, correct the direction, then enter the ramps again. The center of gravity of the machine will change suddenly at the joint between the ramps and the track or trailer, and there is danger of the machine losing its balance. Travel slowly over this point.
When loading or unloading to an embankment or platform, make sure that it has suitable width, strength, and grade. For machines equipped with a cab, always lock the door after boarding the machine. If this is not done, the door may suddenly open during transportation. Refer to "TRANSPORTATION (PAGE 3-143)". (1) (2) (3) (4) Blocks Ramp Centerline of trailer Angle of ramps: Max. 15 ° 2 - 26 If it is necessary to pa rk the machine on a slope, alway s do follow S gr In m follow S et the work equip ment on the downhi ll side an d dig it into ound In achine from mov TRANSPORTATION transported on a trailer, there is danger of serious personal injury or death during o as follows.
achine dimensions carefully. Depending on the work equipment installed, the machine height, and overall length may differ. When t he machine is transported transportation. Always d o as follows Alwa ys check the m achine dimensions weig ht, transportation height, and overal l length may dif fer. Chec k beforehand tha t all bridges and ot her structures o n the transportation route are strong e nough to wit hstand the c ombined weight of the transporter a nd the m achin e being t ransported . The machine can be d ivided into parts fo r transportation , so whe n transport ing the machine, please conta ct your Komatsu distributor to have the w ork car ried out.