. OPERATION EXPLANATION OF COMPONENTS (a) 3 - 24 ADDITIONAL HEATER S (if equi This sw itch (8) is used t o actuate the hot water he (a) posi tion: Hot water h (b) posi tion: Hot water h eater Lo (ON (c) posi tion: Hot water h eater Hi (ON) FAN ROTATION SELECTOR SWITCH Set this switch (9) to the (b) CLN position to select the clean for the f an. he switch is released, it returns automatically to th . When t position When t he clean mode is selected, the fan reversa l lamp ligh When t he clean mode is being used, t urn the switc h (9) to the to retur n to the normal m ode. The fan reversal la mp goes ou The cle an mode is used to blow dust and dirt off th e radiator fins.
In this mode, t he cooling fan rotates a t the fullest speed. When o perating the coo ling fan rotation s elector s witch, turn the engine starting switch k ey to th e OFF position to make s ure that the engi ne is not running. REMAR K oling fan rotation selector switch does not work when it is operated while the engine is running. The co oling fan rotation selector switch d oes not work when it is operated while the engin e is running. In that c ase, the fan rota tion selection impossibility lamp flash es to indicate that t he fan rot ation cannot b e changed.
The co oling fan rotation selector switch returns t o the normal mode, when the engine stops or when the engine the when ngine starting switch key is tur ned to the OFF p osition. For clea ning procedures , see"CLEAN AN D CHEC K RADIAT OR FINS, OIL COOLER FINS , AFTERCOOLER FINS (PAGE 4-37)".