. OPERATION EXPLANATION OF COMPONENTS PARKING BRAKE LEVER WARNING WORK EQUIPMENT LOCK LEVER WARNING Lever (6) is a device to lock the blade control and ripper control levers. 3 - 44 When the ma chine is parke d, always se t the parkin g brake lev er to the LOC This lever ( 5) is used to apply the p arking bra REMARK Before m oving the parking brake lever to the LOCK position (L), return the steering, directional, and gearshift he N position. arting the engine, if the parking brake lever is not in the LOCK position (L), the limit switch is actuated mpossible to start the engine.
arking lever to t he N positio When st arting the en gine, if the parking br ake lever i s not in the and it is i mpossible to start the e ngine. When stan ding up from the operator 's seat, alw ays move th e work e quipment lock lever securel y to the LOCK position If the blad e control and r ipper contr ol levers are not locked and are touched by accident, it may lead to serious injury o damage.
If the work equipment lo ck lev er is n ot complete ly in the LO CK position ( L), the lock may not be Check tha t it is in the po sition show n in t he diag When park ing the machi ne or w hen p erforming maintenance , always lowe r the blade or ripper to t he ground, then set the work equipment lock lever to the LOCK p osition (L). When it is s et to the LOC K position (L), the TI LT, RAISE, LOWER, and FLOAT operations are locked. REMARK When starti ng the engin e, to e nsur e safety, a lways set t he wor k equipment lock lever to the LOCK position ( L).