HOW-TO SECTION J 5956 or equivalent. Authorized Detroit Diesel distributors are properly equipped to perform this service. To avoid cover or vent dap damage, do not use tools to tighten the vent cap. NOTICE: How to Clean the Engine 2. After making sure the O-ring seal is installed on the vent plug, reinstall the plug and tighten by hand only. Important: Observe all environmental protection regulations. High-Pressure Cleaning Equipment NOTICE: Information on suitable cleaning and protective products is available from any authorized dealer. Note the equipment manufacturer's operating instructions.
Do not allow the fuel level in the see-thru cover to fall below the top of the collar, since this may lead to interruption of the fuel flow and engine stalling. NOTICE: 3. Start the engine and allow the lubrication system to reach its normal operating pressure, then increase engine speed to high idle for 2 to 3 minutes. To prevent damage to engine components, keep the water moving at all times while cleaning. Never direct water onto electrical components, plug connectors, seals or flexible hoses. 4. After the air is purged and with the engine still running, loosen the vent cap on the filter cover. The fuel level in the cover will start falling.
When the fuel level falls to the top of the collar on the Fuel Pro cover, tighten the vent cap quickly by hand . To avoid injury, wear a face shield or goggles. NOTE: If the engine fails to start after replacement of fuel filters, the fuel system will require priming with tool Comply with the minimum working distance between the high-pressure nozzle and the surface being cleaned: 104 All information subject to change without notice. DDC-SVC-MAN-0006 Copyright © 2009 DETROIT DIESEL CORPORATION