OPERATING INSTRUCTIONS FOR STARTING THE ENGINE Fuel System Checks Fill the tanks with the recommended fuel. Keeping tanks full reduces water condensation and helps keep fuel cool, which is important to engine performance. Full tanks also reduce the chance for microbe (black slime) growth. For fuel recommendations, refer to How to Select Diesel Fuel in the HOW-TO SECTION of this guide. Make sure the fuel shutoff valve (if used) is open. PERSONAL INJURY To avoid injury from slipping and falling, immediately clean up any spilled liquids. 2. If necessary, top off by filling engine oil through the oil fill cap to the satisfactory fill range on the oil dipstick.
For detailed procedures, refer to the “MAINTENANCE” section. Do not overfill. NOTICE: Prolonged use of the starting motor and engine fuel pump to prime the fuel system can result in damage to the starter, fuel pump and injectors. Extended Storage An engine in storage for an extended period of time (over winter, for example) may accumulate water in the oil pan through normal condensation of moisture (always present in the air) on the cold, internal surfaces of the engine. This may cause erratic engine operation due to the amount of air in the lines and filters from the fuel supply tank to the cylinder head NOTICE:
Failure to eliminate water-diluted lubricating oil may lead to serious engine damage at startup. NOTICE: NEVER use a starting aid such as ether to run the engine until the fuel system is primed. Doing so will result in injector damage. Lube oil diluted by water cannot provide adequate bearing protection at engine startup. For this reason, Detroit Diesel recommends replacing the engine lubricating oil and filters after extended storage. 20 All information subject to change without notice. DDC-SVC-MAN-0006 Copyright © 2009 DETROIT DIESEL CORPORATION