MAN — Man EPA07 Series 60 Engine Operator's Manual

EPA07 SERIES 60 ENGINE OPERATOR'S MANUAL Spin-On Filters Install new spin-on primary and secondary fuel filter elements on vehicle engines every 15,000 miles (24,000 km) or every six months, whichever comes first. See Figure 26. coolant does not leak from the drain hole under normal conditions, do not replace the water pump. Coolant Inhibitor Element If the cooling system is protected by a supplemental coolant additive (SCA) element, the coolant must be tested at required intervals and the element replaced, if required. See Figure 27. Replace spin-on filter elements immediately if plugging is indicated, regardless of mileage or hour intervals.

Item 13 Water Pump and Coolant Inhibitor Element Check the water pump and the coolant inhibitor element. Figure 26 Spin-On Fuel Filter Locations Water Pump Drain Hole The water pump drain hole should be inspected every 6 months to make sure it is open. A small chemical build-up or streaking at the drain hole may occur. This is not an indication of a defective water pump or seal. Figure 27 Coolant Inhibitor Element Required test intervals are listed in Table 24. Remove the build-up with a mild detergent cleaner and a brush. If All information subject to change without notice. 85 DDC-SVC-MAN-0006 Copyright © 2009 DETROIT DIESEL CORPORATION