. OPERATION OPERATION WARMING UP OPERATIONS 1. Turn fuel control dial (1) to the center position between LOW IDLE (MIN) and HIGH IDLE (MAX) and run the engine at medium speed for about 5 minutes with no load. 3. Check for abnormal exhaust gas color, noise, or vibration. problem is found, contact your Komatsu distributor. 3 - 116 NOTICE carry out operations when the hydraulic oil is still at low Do not temper carry o monitor ature, and do not operate the co ut the warming-up operation unti shows the green display. ntrol levers suddenly. Always l the hydraulic oil temperature Performing the warming-up operati Do not s is comp on properly will extend the service life of the machine.
uddenly accelerate the engine before the warming-up operation leted. run the engine under no load at low idling or high idling Do not continu ously for more than 20 minutes. This will have an adverse effect on the e nvironment, and will also have a n adverse effect on the internal structu re of the turbocharger and engin e. If it is necessary to run the engine at idling, apply a load from time to time or run at a mid-range speed. If the e ngine oil pressure monitor on ma chine monitor (2) lights up or the alar m buzzer sounds intermittently, stop the engine and carry out inspect ion. 2. After gaug it completing the warming-u es and monitors work properl p operation, check that all y.
If any problem is found, carry load (2) en (A (A (C out maintenance or repair. until the engine water coolant ters green range (A) - (C). Run the engine under light gauge on machine monitor ) - (B): Red range ) - (C): Green range ) - (D): White range If any