. MAINTENANCE SERVICE PROCEDURE CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL WARNING NOTICE REMARK When inspecting, if the machine is at an angle, move it to a level place to carry out the check. 4 - 59 When remo ving the oil filler cap, oil may spurt out, so st op the engine and wait for the oil temperature t o go down, then turn the cap slowly to release the internal pressure bef ore removing the cap. If oil has be en added to above th e H mark, stop the engin e and wait for the hydrauli c oil to cool down. Th en remove cover (1), loos en drain plug (2), and drai Check the o il level when the oil is at low temperature.
If th e oil is at high temperature , the oil level will be Do not add oil if the oil level is a bove the H line. This ma y damage the oil circuit a nd cause the oil to sp 1. Lower bl ade to the ground and stop the engine . Wait for 5 minutes the H an before checking oil level. Oil level should be between d L in sight gauge ( G). 2. If the oil l evel is below the L line, add oil through o il filler (F) at the top o f the hydraulic tank .