Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 01 (ENGINE MANAGEMENT SYSTEM) GENERAL Engine RPM Limiter The ECM will limit the maximum engine speed. The ECM monitors engine RPM through the CPS and it changes the fuel injection and ignition as necessary. SYSTEM DESCRIPTION There are 7 main systems in interaction with the engine management system: 1. Electronic fuel injection 2. D.E.S.S. system 3. Ignition system 4. Starting system 5. O.T.A.S. (Off-Throttle Assisted Steering) 6. Lubrication system (T.O.P.S. (Tip-Over Protec- tion System)) 7. iControl system Engine Speed Control The ECM controls the engine idle RPM.

It in- creases and reduces the engine speed by using the throttle actuator. The throttle actuator allows many functions for the iControl system. Drowned Mode If engine is fuel-flooded or water-flooded and does not start, this special mode can be activated to prevent fuel injection and ignition while cranking in order to ventilate the engine to dry the cylinder walls. NOTE: This mode can also be used if engine is water-flooded. Proceed as follows to activate it. With safety lanyard on its post while engine is stopped, press and HOLD throttle lever. Press the START/STOP button. The mode is now on. Releasing throttle lever will bring back to its nor- mal mode.

If engine does not start, it may be necessary to remove spark plugs and crank engine with rags over spark plug holes. Refer to IGNITION SYS- TEM subsection. Engine Control Module (ECM) smr2009-027-005 ECM The ECM controls the electrical system and the engine management functions, by processing the information given by various sensors. It also exchange information with the other elec- tronic systems through the CAN bus (information center and iControl System. The ECM is mounted on the intake manifold.

Monitoring System The ECM monitors the electronic components of the fuel injection system, the iControl system, the information center (gauge) and also some compo- nents of the electrical system. For more information, refer to MONITORING SYS- TEM AND FAULT CODES. Limp Home Mode The ECM may automatically use default parame- ters for the engine management to ensure the ad- equate operation of the watercraft if a component of the fuel injection system or iBR is not operat- ing properly. For more information, refer to MON- ITORING SYSTEM AND FAULT CODES. smr2009-027-006_a 1. ECM on intake manifold Diagnostic Mode The ECM features a self-diagnostic mode when pressing the START button.

However, some com- ponents need the engine to be running so that they can be monitored. Some problems will turn on a warning lamp or beeper, or will set the engine smr2009-027 175