Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 02 (iCONTROL SYSTEM) iCONTROL SYSTEM GENERAL iTC (INTELLIGENT THROTTLE CONTROL) The iControl (intelligent Control) system consist of the following systems: Intelligent Throttle Control (iTC) Intelligent Brake and Reverse (iBR) Intelligent Suspension (iS). The gauge is used with the iControl system to nav- igate through and select several functions, modes of operation and change certain settings and sys- tem parameters using the appropriate handlebar control s.
The iTC is an electronic throttle control system that includes a cableless throttle control located on the RH side of handlebar and an electric throt- tle actuator (ETA) located on the throttle body. For a comprehensive and complete description of this system, refer to its subsection in the FUEL SYSTEM section. sdd2009-001-031_a 1. Throttle lever 2. Throttle accelerator sensor (TAS) smo2009-002-119 INFORMATION CENTER (GAUGE) : 9 smo2009-002-200_c HANDLEBAR CONTROL S 1. Handlebar 2. Throttle lever 3. iBR lever 4. Cruise 5. Engine START/STOP button 6. VTS s (Variable Trim System) 7. iS s 8. Information center (gauge) control s sdd2009-001-030_b 1. Throttle body 2.
Throttle actuator (inside) iBR (INTELLIGENT BRAKE AND REVERSE) For a comprehensive and complete description of the information center, refer to GAUGE subsec- tion in the ELECTRICAL SYSTEM section. The iBR is a brake and reverse system that is used to avoid obstacles, gradually slow down or stop the watercraft by lowering the iBR gate that re- verts the water flow at the outlet of the jet pump nozzle. smr2009-047 177