Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 05 ELECTRICAL SYSTEM Subsection 03 (IGNITION SYSTEM) IGNITION SYSTEM SERVICE TOOLS Description Part Number Page ECM ADAPTER TOOL................................................................... 529 036 166 ......................................... 292 FLUKE 115 MULTIMETER ............................................................ 529 035 868 ......................................... 291 SERVICE PRODUCTS Description Part Number Page DOW CORNING 111..................................................................... 413 707 000 .........................................

293 GENERAL The ECM is programmed with data (ignition map- pings), which it uses along with data it receives from a variety of sensors to establish optimum ignition timing under all engine operating condi- tions. The firing of each spark plug is independent of the others. SYSTEM DESCRIPTION The ignition system is a digital inductive type sys- tem. Ignition system parameters such as ignition tim- ing, spark duration, and firing order, are controlled by the ECM in order to meet engine operational requirements. Three separate ignition coils receive power from three separate fuses.

When a ground signal is provided by the ECM to an ignition coil primary winding, a high voltage is induced in the coil secondary winding that is used to produce a spark at the spark plug electrode. Knock Sensor A knock sensor is mounted on the cylinder block behind the intake manifold. It detects specific vi- brations that would typically be generated by en- gine detonation. If detonation occurs, the knock sensor detects it and the ECM goes into a specific operating mode whereby it temporarily retards the ignition advance until detonation stops. The ECM is able to identify in which cylinder the knocking occurs and modifies the ignition advance on that cylinder only.

Refer to the ELECTRONIC FUEL INJECTION sec- tion for testing and replacement procedures. TROUBLESHOOTING DIAGNOSTIC GUIDELINES The following is provided to help in diagnosing the probable source of troubles. It is a guideline and it should not be assumed to list all possible prob- lems. smr2009-032-002_a 1. Ignition coils Ignition Timing Ignition timing is not adjustable. smr2009-032 289