Section 05 ELECTRICAL SYSTEM Subsection 06 (DIGITALLY ENCODED SECURITY SYSTEM (D.E.S.S.)) Start B.U.D.S. and logon. IMPORTANT Approximately 3 minutes after pressing the START button, the ECM will stop communicating with B.U.D.S. Therefore, operations with B.U.D.S. will be interrupted. Other beeps can be heard. The ECM features a self-diagnostic mode. Refer to MONITORING SYSTEM AND FAULT CODES for more informa- tion. To initiate back the communication, briefly press the START button. Do not hold START button to avoid engine cranking . Read ECM using Read Data button. PROCEDURES D.E.S.S. KEY D.E.S.S. Key Recognition To help the key recognition, the following steps are recommended:
Briefly press the START button to wake up the ECM. Install the key on watercraft D.E.S.S. post. Press the START button to start engine. vmr2006-012-100_aen Click on Keys tab. D.E.S.S. Key Programming Perform the required connections for B.U.D.S. Re- fer to COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE for proper connection instructions. Use the latest B.U.D.S. software available from BOSSWeb. IMPORTANT: Ensure all connections have been made before starting B.U.D.S. to allow proper operation. Briefly press START button to power the ECM. Install a D.E.S.S. key, to be added or erased, on watercraft D.E.S.S. post.
smr2005-072-001_en Adding a Key Click on the desired Add Key button on bottom of screen according to the type of key you want to program. WARNING If programming a Learning or Rental key, make sure to use the proper key type (color) to avoid possible confusion. smr2009-035-005_a 1. Key to be added or erased 326 smr2009-035 BEEPER SIGNIFICATION 2 short beeps Indicate a working D.E.S.S. key. Engine starting can take place. 1 long beep Indicates a wrong D.E.S.S. key is being used or something is defective. Engine starting is not allowed.